i
Electrical Safety and Installation
Requirements
RADIATED ENERGY
U.S. Federal Communications Commission
Note: This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with this instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own
expense.
Note: Modifications or changes not expressly approved by the manufacturer or the FCC can void your right to operate this equipment.
Canadian Department of Communications
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appariel numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
SAFETY
ELECTRICAL NOTICES
WARNING: ELECTRIC SHOCK HAZARD
To prevent ELECTRIC shock, do not remove cover. No user-serviceable parts inside. This unit contains HAZARDOUS VOLTAGES and
should only be opened by a trained and qualified technician. To avoid the possibility of ELECTRIC SHOCK, disconnect electric power
to the product before connecting or disconnecting the LAN cables.
This is a “
CLASS 1 LED PRODUCT
.”
LIGHTNING DANGER
DANGER
: DO NOT WORK on equipment or CABLES during periods of LIGHTNING ACTIVITY.
CAUTION: POWER CORD IS USED AS A DISCONNECTION DEVICE.
TO DE-ENERGISE EQUIPMENT, disconnect the power
cord.
INSTALLATION
ELECTRICAL—AUTO VOLTAGE ADJUSTMENT
This product will automatically adjust to any voltage between the ranges shown on the label.
ELECTRICAL—TYPE CLASS 1 EQUIPMENT
THIS EQUIPMENT MUST BE EARTHED.
Power plug must be connected to a properly wired earth ground socket outlet. An
improperly wired socket outlet could place hazardous voltages on accessible metal parts.
ELECTRICAL—CORD NOTICE
Use power cord, maximum 4.5 meters long, rated 6 amp minimum, 250V, made of HAR cordage molded IEC 320 connector on one end
and on the other end a plug approved by the country of end use.
CAUTION
:
Air vents
must
not be blocked
and must have free access to the room ambient air for cooling.
CAUTION
:
DO NOT
detach rubber feet from the product unless an Allied Telesyn vertical mounting chassis is being used.
Operating Temperature
This product is designed for a maximum ambient temperature of
40
°
C
.
All Countries:
Install product in accordance with local and National Electrical Codes.
NORMEN:
Dieses Produkt erfüllt die Anforderungen der nachfolgenden Normen.
Hochfrequenzstörung
EN55022 Klasse A
StörsicherheitEN50082-1
WARNUNG
: Bei Verwendung zu Hause kann dieses Produkt Funkstörungen hervorrufen. In diesem Fall müßte der Anwender
angemessene Gegenmaßnahmen ergreifen
Störsicherheit
EN50082-1
Elektrische Sicherheit
EN60950, UL1950, CSA 950
SICHERHEIT
ACHTUNG: GEFÄHRLICHE SPANNUNG
Das Gehäuse nicht öffnen. Das Gerät enthält keine vom Benutzer wartbaren Teile. Das Gerät steht unter Hochspannung und darf nur
von qualifiziertem technischem Personal geöffnet werden. Vor Anschluß der LAN-Kabel, Gerät vom Netz trennen.
