Installation
16
Installing the AT-4016F ATM Ethernet Switch
The following procedure details how to install an AT-4016F in a
standalone configuration.
Installing the switch
1.
Plug one end of the power cord into the switch’s power receptacle and
the other end into a power outlet.
2.
Check the front panel to see that the Power indicator illuminates for
both power supplies. PS Present 1 indicates Power Supply #1 and PS
Present 2 indicates Power Supply #2. Note that these redundant power
supplies use a load sharing methodology — that is, while a single power
supply provides sufficient power to operate the unit, the MTBF
duration is greatly extended when a dual power supply configuration
operates at half power.
3.
Plug your Ethernet data cables into the AT-4016F and the network
device (DTE). The Link Status indicator for each connected port will
illuminate.
4.
Please refer to the troubleshooting section of this manual if any on line
LEDs are not functioning. Note that any communication between a
node and the switch requires Omega management. LAN Emulation, in
particular, requires Omega management.
5.
The AT-4016F is now functional and ready to operate; see
CentreCOM
AT-4016TR Ethernet Switch — Operations Manual
for details.
6.
The following information only pertains to those who are going to
attach the ATM portion of your switch at this time.
Attach one end of your fiber optic cable to the ATM Physical
Interface Module at the back of the AT-4016F and the other end to
the ATM port. The ATM Online LED should illuminate.
Additionally, if the Loss of Signal (LOS) LED illuminates, the fiber
pairs are either crossed (incorrectly installed) or there are other
cable problems.
