Error Code Programming
Error-
E StHt
E StHt
Slow to Heat Error (Heater/Temp Sensor
only) - If programmed to off, then the er-
ror is disabled. The control will show the
error during the cycle if the water tem-
perature has not changed 5°C from the
start of heating within the programmed
time in minutes. The cycle will continue
normally even if the error is set. Any
keypress will clear the error display.
E Ht-
Heater Error Menu (Heater/Temp Sensor
only)
E Ht 1
Heater Error (On/Off) - If Enabled, will
set error after heater error alarm time if
target water temperature isn't reached, if
disabled will allow heating forever until
target temperature is reached. Shown at
end of cycle until the door is opened or a
key is pressed.
E Ht 2
Heater Error Time - Time allowed in mi-
nutes to reach target water temperature
before setting the heater error.
E tE
E tE
Water Temperature Exceeded (Heater/
Temp Sensor only) - Helps to detect a
stuck heater relay by setting error if the
maximum water temperature allowed has
been exceeded for 10 minutes. Shown at
end of cycle for one minute, after the
door is opened or a key is pressed.
E Ub
E Ub
Non-Fatal Unbalance Error - Error
shown at end of cycle if load has been
detected to be out of balance during the
cycle. Shown after the door is opened or
a key is pressed. This error will remain
displayed until another key has been
pressed or one minute passes.
E SL
E SL
Suds Lock Error Display - Shown at end
of cycle after the door is opened or a
keys is pressed if suds were still detected
in the machine after all Suds Removal
Routines allowed have been run in the
cycle. Will be cleared after one minute or
if a key is pressed.
Table 5
continues...
Programming Control
©
Published by permission of the copyright owner -
DO NOT COPY or TRANSMIT
54
Part No. 805405ENR5
Содержание BT3JGASG403UW01
Страница 2: ......
