Error Code Programming
Error-
E Ld-
E Ld-
Water Leak Detection Error Menu - This
error checks for whether the machine is
leaking water by adding 1 minute to the
cycle to check for water leaks.
E Ld 1
Water Leak Detection Day(s) of Week
Enable - Allows owner to pick which
days to check for water leaks.
E Ld 2
Water Leak Detection Number of Cycles
Between - Sets how many cycles must
run before water leaks are checked again.
E Ld 3
Water Leak Detection Display Sequence
(On/Off) - Will show a moving dash "-"
across the 7-segment display while the
water leak detection is being performed.
E Sd-
Slow Drain Detection Error Menu
E Sd 1
Slow Drain Detection (On/Off) - Ena-
bles/Disables the error
E Sd 2
Slow Drain Detection Adjust - Allows
the owner to add time in seconds to the
machine's default draining time used to
detect for slow draining conditions.
Helps allow for locations with poor
draining conditions.
E oP
E oP
Open Thermistor Error Display (Heater/
Temp Sensor only) - Error shown at end
of cycle if the temperature is detected to
be less than/equal to 32F/0C while heat-
ing.
E SH
E SH
Shorted Thermistor Error Display (Heat-
er/Temp Sensor only) - Error shown at
end of cycle if the temperature is detec-
ted to be greater than 212F/100C while
heating.
Table 5
continues...
Programming Control
©
Published by permission of the copyright owner -
DO NOT COPY or TRANSMIT
53
Part No. 805405ENR5
Содержание BT3JGASG403UW01
Страница 2: ......
