ALLIANCE ALLWH3.2kW, Техническое руководство

Страница: 23 / 39

AA –HP410-2011-02 Alliance Cycle-Heating Domestic Heat Pump Water Heater Technical Manual
23
1. Precautions
Be sure to conform to local, national and international laws and regulations.
Read "PRECAUTIONS" carefully before installation. They include important safety items.
Keep this manual with the owner's manual for future reference.
The safety precautions listed here are divided into two categories. As these are important, please read them
both carefully.
WARNING:
(Failure to observe the warnings below could result in fatal injury)
Only trained and qualified service personnel are to install, repair or maintain the equipment.
Improper installation, repair or maintenance may result in electric shock, short-circuits, leaks, fire or other
damage to the equipment.
The unit must be installed strictly according to these installation instructions.
Defective installation could cause water leakage, electric shock or fire.
Ensure that the attached accessories and specified parts are used for installation, otherwise water leakage,
electric shock or fire may result.
The unit is to be installed on a suitably strong wall able to withstand the unit's weight. An improperly done
installation may result in damage to the unit or the unit becoming detached from its mountings.
The enclosure of the appliance is to be marked by word or symbols, indicating direction of fluid flow.
For electrical work, local and national wiring standards are to be adhered to. An independent circuit and
single outlet must be used.
Improper connection or fixing may cause overheating or fire at the connection point.
Routing of wiring must be properly carried out, and the control board cover fixed in place. An improperly
fixed control board cover may cause overheating at terminal connection points and fire or electric shock.
If the supply cord is damaged, it must be replaced by the service agent or other qualified person in order to
avoid a potential hazard.
An all-pole disconnection device which has at least 3mm separation distance in all poles and a residual
current device (RCD) with a rating above 10mA must be incorporated in the fixed wiring according to
national regulations.
In areas prone to strong winds, typhoons or earthquakes, consideration must be taken into account during
installation.
If any refrigerant leak occurs during installation, ventilate the area immediately.
As the temperature of refrigerant pipe will be high, please keep the interconnection cable away from it.
After completion of installation, check for any leakage of refrigerant.
Toxic gas may be produced if refrigerant leaks into an enclosed room and comes into contact with a source
of fire such as a fan heater, stove or cooker.
CAUTION
Failure to observe the cautions listed below may result in injury, or damage to the equipment.
After the installation is completed, make sure that the unit is operating properly during the trial operation.
Please instruct the customer on how to operate the unit and keep it maintained. Also, inform customers to
keep this manual for future reference.