Alliance Laundry Systems ZWC372-3059, Сервисная инструкция

Страница: 42 / 76

40
37987
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
IMPORTANT: When installing outer tub cover,
always use a new cover gasket.
NOTE: Clean and remove any foreign material in
gasket groove of outer tub cover and outer tub
flange.
g. Starting at positioning pin located between two
bleach funnel outlet tabs, lay gasket into gasket
groove of tub cover. Refer to Figure 33.
h. Using your fingers, press gasket down into
gasket groove of tub cover. Avoid pressing
gasket past ends of hold-down tabs.
IMPORTANT: Care must be taken not to twist or
bunch gasket in any one area to avoid leaks after
assembly.
i. Install gasket past ends of hold-down tabs to
bottom of gasket groove using semi-curled end
of tub cover tool Part No. 273P4. Refer to
Figure 33.
NOTE: Tub cover tool part No. 273P4 is designed to
spread open hold-down tabs to prevent tearing of
gasket during installation.
j. With tub cover tilted at approximately a 45
degree angle, insert the positioning pin into
notch on outer tub flange. Refer to Figure 34.
NOTE: The two bleach funnel outlet tabs must be
angled downward toward inside wall of outer tub
for proper dispensing of bleach.
k. Lower cover and push down firmly on top of
hold down tabs next to positioning pin until tabs
snap over edge of outer tub flange.
l. Cross over to opposite side of tub cover and
push down firmly on top of hold down tabs
until tabs snap over edge of outer tub flange.
Continue with this criss-cross pattern, until tub
cover is fully seated. Visually check each tab
area again to ensure cover is seated.
m. Check whether or not bleach drain tabs are in
the down position by looking through the
square holes in bleach funnel area of tub cover.
If tabs are not down, a small screwdriver can be
inserted down through holes in bleach funnel
area to straighten tabs.
(continued on page 42)
Figure 33
Hold-Down
Tab s
W20 8S E 3 A
Hold-Down
Tab s
Pre ss Ga s ket Into
Groove U s in g Your
Fin g er s
27 3 P4
Tub Cover
Tool
Bleach
Drain Tab s
Tub Cover
Ga s ket