Alliance Laundry Systems ZWC372-3059, Сервисная инструкция

Страница: 40 / 76

38
37987
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
36. MIXING VALVE ASSEMBLY
a. Remove two screws from bottom edge of front
panel. Refer to Figure 25.
b. Pull bottom of panel away from washer until
hold-down clips (located on top flange of
panel) disengage from slots in cabinet top.
Refer to Figure 25.
c. Remove two cabinet top hold-down screws.
Refer to Figure 25.
d. If area or space permits, tape loading door
closed and lift cabinet top to a vertical position
by hinging it on rear hold-down bracket.
NOTE: Cabinet top is self-supporting, however, a
small chain may be used for additional support.
Refer to Figure 26.
IMPORTANT: Before lowering cabinet top into
position, pivot outer tub forward far enough to
prevent damaging (bending) the out-of-balance
switch lever. Refer to Figure 28.
e. Remove two screws holding mixing valve to
mounting bracket at rear of washer cabinet.
Refer to Figure 31.
NOTE: When installing mixing valve, tab on
bottom flange must be placed in positioning hole in
mounting bracket.
f. Pull mixing valve out toward front of washer
far enough to permit disconnecting water inlet
and fill hoses from mixing valve. Refer to
Figure 31.
g. Remove wires and quick disconnect blocks
from mixing valve solenoid terminals. Refer to
Figure 31.
NOTE: Refer to appropriate wiring diagram when
rewiring solenoids.
Figure 31
H
C
Ho s e
Clamp
Filler
Ho
s e
Wire
Harne ss
Di s connect
Terminal s
Mixin g
Valve
Attachin g
S crew s
Earth
(Ground)
S crew