W005I_SVG
2
1
1.
Risers (Air cushions)
2.
Water Supply Faucets
Figure 7
Non-Gravity Drain Models - Connect
Drain Hose to Drain Receptacle
Remove the drain hose from its shipping position on the rear of
the washer by removing the shipping tape.
IMPORTANT: Drain receptacle must be capable of han-
dling a minimum of 1-3/8 inch [35 mm] outside diame-
ter drain hose.
Drain Flow Rate
Drain Height
Flow Rate
gallons per minute [lit-
ers per minute]
3 ft. [0.9 m]
8.6 [32.7]
5 ft. [1.5 m]
6.8 [25.9]
6 ft. [1.8 m]
6.0 [22.7]
7 ft. [2.1 m]
5.1 [19.5]
8 ft. [2.4 m]
4.0 [15.2]
Standpipe Installation
1. Place the drain hose into the standpipe.
2. Remove the beaded tie-down strap from accessories bag and
place around standpipe and drain hose and tighten strap to
hold hose to standpipe. Refer to
Figure 8
. This will prevent
the drain hose from dislodging from drain receptacle during
use.
SWD1026N_SVG
2
3
1
1.
24 to 36 in. [610 to 914 mm] Recommended Height
2.
Beaded strap from accessory bag
3.
Standpipe 2 in. [51 mm] or 1-1/2 in. [40 mm]
Figure 8
Gravity Drain Models - Connect Drain
Outlet to Drain System
Maximum flow rate is 24 gallons/minute [90.8 liters/minute].
Flow rates will vary with load type.
1. Remove drain fitting (4 inches [102 mm] long) and hose
clamp from accessories bag. Insert drain fitting into drain out-
let hose. Clamp hose and fitting.
2. Connect the drain fitting to a vented drain system using a
flexible connection (obtain locally). Inside diameter of fitting
is 1.53 in. [39 mm] and outside diameter is 1.66 in. [42 mm].
3. The drain system must be vented to prevent an air lock or si-
phoning.
IMPORTANT: Increasing the drain hose length, in-
stalling elbows, or causing bends will decrease
drain flow rates and increase drain times, impairing
machine performance.
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
17
Part No. 805419R3
Содержание SWD455C SVG
Страница 2: ......
