Alliance Laundry Systems AT0350SRG, Руководство по обслуживанию

Страница: 31 / 60

70143101
29
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To Re-Install Belt
Refer to Figure 19 .
(1) Reach into cabinet through drive access
cover and apply downward pressure on
idler pulley until idler lever clears idler lock
bracket. Insert a screwdriver through hole
in bracket.
NOTE: Use a #3 Phillips screwdriver that is at least
8 inches long.
(2) Slowly release pressure until idler lever
rests on screwdriver shaft.
(3) Carefully install belt.
(4) Apply downward pressure on idler lever
until it is possible to remove screwdriver.
IMPORTANT: Removing screwdriver without first
relieving pressure on the idler lever will cause idler
to snap back into place. This could cause injury to
the person, the person’s hand or damage the tumble
dryer.
(5) Slowly release pressure until idler pulley
seats with the belt.
(6) Rotate cylinder by hand to check that the
belt is tracking properly.
NOTE: Turn the cylinder clockwise if rotating from
the front of the tumble dryer and counterclockwise
from the rear.
(7) Replace drive access cover and guard.
(8) Connect power to tumble dryer and check
for proper operation.
STAND ALONE TUMBLE DRYER
a. Remove control panel. Refer to Paragraph 18 .
b. Remove lint panel. Refer to Paragraph 19 .
c. Remove front panel. Refer to Paragraph 16 .
d. Remove drive access cover. Refer to Figure 31 .
e. Lift motor up and run belt off pulley.
f. Remove cylinder.
g. Remove four screws holding idler bracket to
tumble dryer and remove idler.
Use extreme care when idler lever is in this
position; it is spring loaded. If screwdriver
is accidentally removed, serious injury
and/or damage to the tumbler could result
from idler lever slamming back into
position.
W231
CAUTION
Figure 19
T292SE1A