Alliance Laundry Systems AT0350SRG, Руководство по обслуживанию

Страница: 24 / 60

22
70143101
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
18. CONTROL AND COIN DROP ASSEMBLY
STACKED TUMBLE DRYER
Refer to Figure 7 .
a. Unlock control/coin drop.
b. Push down and in on bottom of control. Top of
control will tilt forward.
c. Pull control out far enough to disconnect wires.
d. Remove control and place in a clean, dry
location where it cannot be damaged.
IMPORTANT: Refer to wiring diagram when
rewiring control.
STAND ALONE TUMBLE DRYER
Refer to Figure 8 .
a. Unlock top access panel over control and
remove. Refer to Figure 4 .
b. Remove two screws from control door.
c. Swing out control.
d. Push up on control until top hinge clears slot.
e. Disconnect wire harness from cabinet harness.
f. Remove audit switch by pressing in on locking
tabs, pull out through front.
g. Remove control and place in a clean dry
location where it cannot be damaged.
IMPORTANT: Refer to wiring diagram when
rewiring control.
Figure 7
ST
AR T
25
C
HIG
H TE MP
ME
D TE MP
LO W
TE MP
NO HE
AT
1
2
3
SE LE
CT TE MP
INS
ER T CO
IN
PU SH
ST AR T
1
2
3
SE LE CT TE
MP
INS
ER T CO IN
PU SH ST
AR T
STA
RT
25
C
HIG H
TE MP
ME D TE
MP
LO W TE
MP
NO HE
AT
T313SE1A
CONTROL
CONTROL
LOCK
COIN
VAULT
(Obtain
Locally)
Figure 8
ST AR
T
25
C
HIGH
TE MP
MED
TEMP
LOW TEMP
NO HE
AT
1
2
3
SEL
ECT TEMP
INSER
T
COIN
PU
SH ST
ART
TMB1753S
CONTROL
DOOR
SCREWS
COIN
VAULT
(Obtain
Locally)
AUDIT
SWITCH
LINT
PANEL
LOCK
LINT
PANEL