Alliance Laundry Systems AES17AWF, Сервисная инструкция

Страница: 59 / 82

512176
57
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
59. TERMINAL BLOCK OR POWER CORD
a. Terminal Block:
(1) While supporting the access panel, remove
two screws from bottom edge of access
panel. Refer to
Figure 8 .
(2) Gently lower the access panel to disengage
locators from bottom edge of front panel.
Refer to
Figure 17 .
(3) Remove two screws holding bottom tabs on
front panel to dryer side panels. Refer to
Figure 9 . Swing bottom of front panel away
from dryer far enough to disengage hold-
down clips and locators from cabinet top.
(4) Disconnect wires from door switch. Refer
to Figure 16 .
NOTE: Refer to wiring diagram when rewiring
switch.
(5) Remove two cabinet top hold-down screws.
Refer to Figure 10 .
(6) Lift cabinet top to a vertical position by
hinging it on the rear hold-down brackets.
Refer to
Figure 11 .
NOTE: When servicing, cabinet top may be raised
and hinged on the rear hold-down brackets, or
supported against wall behind the dryer.
(7) Remove all wires from terminal block.
NOTE: Refer to wiring diagram when rewiring
terminal block.
(8) Remove screw holding terminal block to
rear bulkhead. Refer to Figure 39 .
NOTE: Do not let terminal block insulation drop
when removing the block. Insulation must be in
place when reinstalling block.
Figure 39
D406S
Terminal
Block
Cabinet
Top
Terminal Block
Attaching
Screw