505048
9
Installing the Dryer . . .
Step 1:
Position and Level
the Dryer
For further assistance refer to Section on
Location
Requirements
.
Install dryer before washer. This allows room for
attaching exhaust duct.
Install the four rubber cups found in the accessory bag.
Place the dryer in position, and adjust the legs until the
dryer is level.
Step 2:
Connect Dryer Exhaust System
For further assistance refer to Sections on
Location
Requirements
and
Dryer Exhaust Requirements
.
• DO NOT use plastic or thin foil flexible ducting.
• Locate dryer so exhaust duct is as short as possible.
• Be certain old ducts are cleaned before installing your
new dryer
• Use 4" (10.2 cm) diameter rigid or flexible metal duct.
• Use as few elbows as possible.
• Use duct tape on all joints.
• Failure to exhaust dryer properly will void
warranty.
NOTE: Venting materials are not supplied with the
dryer (obtain locally).
IN US
E
PERM
PRES
S
NORM
AL
FLUFF
(NO H
EAT)
DELIC
ATE
PUSH TO
STAR
T
FABR
IC SE
LECT
OR
50421
0
OPERATING IN
STRUCTIONS
CLEA
N LIN
T FIL
TER A
FTER
EAC
H LO
AD
1.
2.
3.
4.
5.
6.
Select
Fabric
Type (h
eat set
ting)
N
ORMA
L, PER
M PRE
SS,
D
ELICAT
E, FLU
FF (no
heat)
Load C
lothes.
Insert C
oin(s)/C
ard.
To Sta
rt Drye
r - Clos
e Door
and Pu
sh Star
t.
To Sto
p Drye
r Durin
g Cycle
- Open
Door.
To Res
tart Dry
er - Clo
se Doo
r and P
ush Sta
rt.
Drying
Cycle i
s Comp
lete Wh
en
Panel L
ight Go
es Off.
D384IE1A
LEVEL
DRYER
BASE
LEVELING
LEG
RUBBER
CUP
A clothes dryer produces combustible lint. To
reduce the risk of fire and combustion gas
accumulation the dryer MUST be exhausted
to the outdoors.
W116
WARNING
D367IE1B
DO
DON'T
D370IE1A
(continued))
