Allfett ALL-1 PS, Руководство пользователя, Страница: 14 / 24

PAGE
13
www.allfett.net
INTEGRATED CONTROL CARD PROGRAMMING INSTRUCTIONS
4.
After second digit saved, time unit leds start to flash.
ADDITIONAL CYCLE
button changes
the time units. Press Additional cycle button until desired time unit is flashing. Press
SERVICE
button to save
time unit.
5.
After seting working time unit, first digit on program display and yellow led start to flash. Waiting
time period will be set.
8.
After second digit saved, time unit leds start to flash.
ADDITIONAL CYCLE
button changes
the time units. Press Additional cycle button until desired time unit is flashing. Press
SERVICE
button to save
time unit.
2. ADDITIONAL CYCLE
button changes the numbers shown in flashing digit. Press Additional
cycle button until desired number shown in flashing digit. Press
SERVICE
button to save digit.
3.
After first digit saved, second digit starts to flash.
ADDITIONAL CYCLE
button changes the
numbers shown in flashing digit. Press Additional cycle button until desired number shown in flashing digit.
Press
SERVICE
button to save digit.
6. ADDITIONAL CYCLE
button changes the numbers shown in flashing digit. Press Additional
cycle button until desired number shown in flashing digit. Press
SERVICE
button to save digit.
7.
After first digit saved, second digit starts to flash.
ADDITIONAL CYCLE
button changes the
numbers shown in flashing digit. Press Additional cycle button until desired number shown in flashing digit.
Press
SERVICE
button to save digit.
While integrated control card is on, If ADDITIONAL CYCLE button pressed 2 seconds long remaining
time period will be shown on program display.
SERVICE and ADDITIONAL CYCLE buttons, where placed onto control card panel, are used for
programming control card.
1.
Press
SERVICE
Button twice to enter program mode. After entering program mode first digit
on program display and green led start to flash. Working time period will be set first.
Working time period is saved and setted. After this section waiting time period wil be set.
Waiting time period is saved and setted. Programming of the Integrated control card is now
complated. Integrated control card starts the pump with working time period.
While programming, the time interval for pressing buttons must be in 20 seconds. If
20 seconds passes electronic control card exits from the program menu and operations
done before is lost. In this case, card will start to operate with last succesfull programming
values.
In case of power breakdown while pump runs at waiting or working time periods, control
card will remain it’s position before breakdown and resume after power comes. Power
breakdown does not make any change on the structure of the previous program.