Physically align the paving rollers so that they are parallel with the
upper carriage. Stretch a string line across the top of each side of
the upper carriage. Make sure that the string line contacts the inner
flange of the carriage rail. If your machine is equipped with a car-
riage lift option, make sure that it is in the down position. Place a 4
foot long straight edge across the top or the bottom of both ends of
the paving rollers. Loosen the bolts holding the roller bearings on the
front of the lower carriage and the bolts that support the roller motor
mount plates on the back of the lower carriage. Do not remove the
bolts. Using a tape or carpenters rule, measure down from the string
line to the top of the straight edge. At this point the distance is arbi-
trary but must be the same at all four corners. Adjust the distance
of each roller end by turning its adjuster bolt clockwise to raise the
roller and counter clockwise to lower the roller. When all four corners
are of equal distance from the string line the paving rollers will be
parallel with the carriage rail. Replace all shields and tighten all loose
mounting bolts. Using the auger adjusting crank, reset the augers to
1/8” to 1/4” above the bottom of the paving rollers.
Roller
Adjustment Bolt
Roller Mount Plate
Roller Bearing
SECTION 2
OPERATIONS
050362
Page 35
2.5 - Machine Setup, continued
Содержание BDF4836B
