BRIDGE DECK FINISHER SET-UP GUIDE - 069596
Page 19
Customer Notes
SYMPTOM
CAUSE
REMEDY
Roller tubes on carriage will
not work in non-reversing
mode once the lever is shift-
ed on reversing valve
Cartidges are stuck in the MV1 and
MV2 locations on reversing valve
Replace both cartridges
Carriage blower over relief
when in auto reverse after
the shift
if the carriage only works in one direc-
tion in auto reverse move, the MV1 or
MV2 cartridge is stuck
Remove the 9/16 Vent Cap on both the MV1
and MV2 Cartridges. Insert a small screw-
driver or allen wrench into the vent cap holes.
.The cartridge with the shallowest hole is the
cartridge that is stuck. To get by until part
is available, use small screw driver or allen
wrench to manually push the cartridge spool
in. If the depth is the same on both cartridges
then you have successfully shifted the car-
tridge. The carriage will work in auto until the
lever is switched.
