4
iPS10
User Guide
Important Mains plug wiring instructions.
The power supply unit is supplied with a moulded mains plug fitted to
the AC mains power lead. Follow the instructions below if the mains
plug has to be replaced.
The wires in the mains lead are coloured in accordance with the
following code:
WIRE COLOUR
TERMINAL
European USA/Canada
L
LIVE BROWN BLACK
N
NEUTRAL BLUE
WHITE
E
EARTH GND
GREEN & YELLOW
GREEN
The wire which is coloured Green and Yellow must be connected to
the terminal in the plug which is marked with the letter E or with the
Earth symbol.
This appliance must be earthed.
The wire which is coloured Blue must be connected to the terminal in
the plug which is marked with the letter N.
The wire which is coloured Brown must be connected to the terminal
in the plug which is marked with the letter L.
Ensure that these colour codes are followed carefully in the event of
the plug being changed.
Precautions
Damage :
To prevent damage to the power supply unit cosmetics, avoid placing
heavy objects on the unit, scratching the surface with sharp objects,
or subjecting the power supply unit to rough handling and vibration.
Environment :
Protect from excessive dirt, dust, heat and vibration when operating
and storing. Avoid tobacco ash, smoke, drinks spillage, and
exposure to rain and moisture. If the power supply unit becomes wet,
switch off and remove power immediately. Allow to dry out
thoroughly before using again.
Cleaning :
Avoid the use of chemicals, abrasives or solvents. The power supply
unit is best cleaned with a soft brush and dry lint-free cloth. If the
ventilation grilles become blocked with dust use a vacuum cleaner to
suck the dirt out. Do not remove the cover to clean the unit.
Transporting :
The power supply unit should be transported in the original packing
or purpose built flightcase to protect it from damage during transit.
DC
power
cable:
Plan the location of the mixing console and power supply unit so that
the DC power and CAT5 cables are not fully extended. Full extension
of the cable can stress the mixing console and power supply unit
connectors and may result in undesired performance. Ensure that
the power cable is located such that it cannot be stood on or tripped
over.
