FAS-SLIDECH300BBUP SLIDING GATE OPERATOR
4
Anchors
You can use the anchors that are provided with the operator, 3 ¾ anchor bolts (4), anchors, washers, and
nuts. These anchors must be set into the concrete when it is poured, or you can use wedge anchors
(1/4” x 4”).
Operator Base
Mount the gate operator base to the concrete pad. The distance between the gate and the base should
be no more than 2 ½ “ (64mm). Verify that the operator is leveled properly.
Concrete pad
Input power
Chain box
Anchor bolt
Nut
Plain washer
Gate operator
Spring washer
Fig.2
Chain Box
Make sure the ends of the guide chain are out of the chain holes on both sides of the chain box.
Remove the cover and insert the manual release key and turn counter-clockwise to disengage the clutch.
Remove the elastic band from the shaft and line up the key on the shaft with the sprocket at the chain box.
Insert the sprocket from the chain box into the operator shaft. Place the operator on top of the base and
u
se (4) 5/8 “ (M8x15mm) socket head cap screws to mount the chain box in to the base.
Operator
Mount the gate operator to the base using (4) 2 ¾ “ (M8x70mm) #48 bolts and washers. Make sure
there is no more than 1/8” (2mm) of space between the cover and the chain box. Check the operator
and make sure it is lined up with the gate.
