FAS-SLIDECH300BBUP SLIDING GATE OPERATOR
3
4.
Mechanical Installation
The FAS-SLIDECH300BBUP will handle gate weighting up to 300kg and up to 8m if the proper
installation procedures have been followed.
The FAS-SLIDECH300BBUP gate operator operates by forcing a drive chain by a drive chain wheel.
The entire configuration is shown in the diagram below. The gate operator must be installed on the inside
of the gate.
Chain bracket
Upper guiding
Chain
Input power
Socket and plug(waterproof )
Wall
Sliding gate
Gate operator
Fig.1
Installation and Adjustment
The FAS-SLIDECH300BBUP Chain-driven Gate Operator operates by forcing a straight piece of chain
through its chain box. This length of chain is extended between two chain brackets located at opposite
ends of the gate. The entire configuration is shown in the pack list.
Concrete Pad
The base unit of the gate operator requires a concrete pad in order to maintain proper stability. The
concrete pad should be approximately 24” (600mm) x 12” (300mm) x 18” (460mm) deep in order to
provide for adequate operation.
Once the gate is mounted adequately, electrical power is available, and the concrete pad is poured, you
are ready to proceed.
