7
battery powered torque multiplier
4.2 Preparing for work with the power tool
Before preparing the power tool for work remove
the
alkitronic®
Li-Ion battery pack
from the tool.
Depending on the specific job various
alkitronic®
STACO/
STABI/DMA
or special adapters for tightening and loosening
of bolted connections are needed.
•
Push the
STACO / STABI
(11)/(12) onto the square drive
(bore holes of the adapter and of the square must be
aligned).
•
Insert safety pin (13), secure with rubber ring (14) or com-
pletely tighten
STABI
safety screw (15).
10
alkitronic®
STABI
12
15
alkitronic®
STACO
11
14
13
For
DMA
s without safety lock a safety washer is available as
an accessory. This washer prevents a loosening of the
DMA
and can be pushed over the gear cogs and screwed tight.
9
DMA
safety screw
DMAR
safety washer (accessory)
alkitronic®
DMA
•
Place the
alkitronic®
EAF
on a flat surface.
•
If the
DMA
(reaction torque absorber) is fitted with a
safety screw, completely remove this screw (the position
of this screw varies between the tool types).
•
Push the
DMA
(9) onto the gear cogs (10).
•
Tighten the safety screw completely to secure the
DMA
.
5. Electric operation
5.1 Switching on / off
D
Switching on:
Push and hold button (D). The electronic con-
trol system will ensure a soft start.
Switching off:
Release button (D).
Note: The noise that will be emitted during starting is due
to the construction of the tool and has no influence on the
function or longevity of the machine.
Never block the rocker switch, this would make
proper operation impossible.
