56
Basic Setting > Network > PPPoE (Dial-up Networking Setting)
Point-to-Point Protocol over Ethernet is a protocol that supports access to a high-speed wideband
network using a PC and a wideband modem (such as xDSL, Cable, Wireless modem). The user
need only to equip the PC with an Ethernet card and apply to an ISP and an ADSL provider (such
as Chunghwa Telecom) for ADSL service to roam the Internet through ordinary twisted copper
wires.
PPPoE setting must be executed in the LAN environment for your PC to connect to ADSL. Follow
the steps below to complete the setting:
1. Dial: You can select whether or not to dial when you boot the machine.
2. Use DHCP or fixed IP for connection to the LAN environment.
3. Key in the IP address of the camera and enter "PPPoE Setting" following the route Setting
Basic Setting
Network
PPPoE.
4. Key in the xDSL "Username" and "Password" acquired from your ISP. Click
Save
to
confirm the setting.
5. Where the ADSL modem and the camera is connected via a switch-hub, you can press
“Reboot” or restart the machine manually to try PPPoE dialing when the setting of the
camera has been completed.
6. A different IP address is obtained after each dial-up network connection. You can get the
new IP address from Setting
Basic Settings
System. If you want to know the new IP
address anytime, you must enter Setting
Basic Settings
Notification to set some
settings. There are three ways to get information: 1. SMTP 2. FTP 3. HTTP. For details, refer
to the Notification Setup Menu.
NOTE
：
You can use the DDNS function to access the camera. Refer to the “DDNS Setting” page for more information.
