14
Bracket Installation
The product can be fixed on the wall (Fig. 1) or hung from the ceiling (Fig. 2).
When using the attached bracket and screws to fix the product. Please refer to the following
steps:
1. Prepare the bracket
2. Reverse ALS-7721 then check the screw holes
3. Prepare the 4 screws to mount the bracket through screwdriver and screw.
4. After install the all screw, reverse ALS-7721 to finish the installation.
Make sure that no steel bars or power cables exist behind the position where the product is to be
fixed. Some walls or ceilings may not be strong enough to support the bracket and the product. Pay
attention during installation to avoid injury that might be brought about due to falling of the product.
Attention:
The horizontal angle is important when you hang the product from the ceiling. Excessive inclination
may bring about abnormal rotation of the camera lens.
Fixed on a wall (Fig. 1)
Fixed on a ceiling (Fig. 2)
NOTE
：
Product location: You can install the product on the holder and hang it on the wall or ceiling. Please do not install this
product in locations of poor ventilation. This will result in poor operation.
This product is not waterproof. Please install the product inside a waterproof case equipped with an arrestor when using
it outdoors.
