WARNING:
This Alinco transceiver generates RF EME while transmitting. RF EME
(Radio Frequency Electric and Magnetic Energy) has the potential to
cause slight thermal, or heating effects to any part of your body less
than the recommended distance from this radio transmitter's antenna.
RF energy exposure is determined primarily by the distance to and the
powerof the transmitting device. In general, RF exposure is minimized
when the lowest possible power is used or transmission time is kept to
the minimum required for consistent communications, and the greatest
distance possible from the antenna to the body is maintained. The
transceiver has been designed for and is classified for Occupational Use
Only. Occupational/ controlled exposure limits are applicable to situations
in which persons are exposed to RF energy as a consequence of their
employment, and such persons have been made aware of the potential
for exposure and can exercise control over their exposure. This means
you can use the transceiver only if you are aware of the potential hazards
of operating a transceiver and are familiar in ways to minimize these
hazards. This transceiver is not intended for use by the general public in
uncontrolled environments. Uncontrolled environment exposure limits are
applicable to situations in which the general public may be exposed to
■
RADIO FREQUENCY ENERGY SAFETY INFORMATION
This Alinco transceiver has been tested and complies with the
standards listed below, in regards to Radio Frequency (RF) energy and
electromagnetic energy (EME) generated by the transceiver.
• FCC RF exposure limits for Occupational Use Only. RF Exposure limits
adopted by the FCC are generally based on recommendations from the
National Council on Radiation Protection and Measurements, and the
American National Standards Institute.
• FCC OET Bulletin 65 Edition 97-01 Supplement C
• American National Standards Institute (C95.1 - 1992)
• American National Standards Institute (C95.3 - 1992)
FOR HOME OR OFFICE USE
Information in this document is subject to change without notice or
obligation. All brand names and trademarks are the property of their
respective owners. Alinco cannot be liable for pictorial or typographical
inaccuracies. Some parts, options and/or accessories are unavailable
in certain areas. Changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to
operate the equipment.
INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE FCC
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can generate radio frequency
energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that the interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer for technical assistance.
Tested to Comply
With FCC Standards
