28
11
This feature clones the programmed data and parameters in the master unit to slave units.
Use commonly available audio-cable with 3.5 mm stereo-mini plugs as shown below. Make a master unit by setting and programming it as desired.
1.
Turn off both units. Connect the cable between the DATA jacks on both units.
Press and hold
2.
key, then press
key to enter into cloning mode, LCD displays "
CLONE
". Both units must be in the cloning mode.
Cable Clone
If the data is not successfully transmitted, turn off both units, make sure the cable connection is correct and repeat the entire operation from the beginning.
GND
Not in use
DATA TX/RX
Master/Slave stereo plug,3.5mm plug
Press master unit's [PTT] key, LCD displays "SD XXX". Slave unit displays "LD XXX". When the cloning is successfully finished, the master and
3.
slave unit both display "
PASS
". Turn off the power, disconnect the cable and repeat step 2 to step 3 operations to clone the next slave unit.
