4
2
Initial Installation
Before connecting the DC power to the transceiver, be sure to switch
the transceiver and the DC power supply OFF.
Do not plug the DC power supply into an AC outlet until you make all
connections.
In order to use this transceiver for fixed station operation, you will
need a separate 13.8V DC power supply (not included) , Please
contact local dealer to require.
The current capacity of your power supply must be 12A or more.
Connect the DC power cable to the regulated DC power supply
1.
and ensure that the polarities are correct. (Red: positive, Black:
negative).
Never directly connect the transceiver to an AC outlet.
Use the supplied DC power cable to connect the transceiver to a
regulated power supply.
Do not substitute a cable with smaller gauge wires.
Connect the transceiver's DC power connector to the connector
2.
on
the DC power cable.
Press the connectors firmly together until the locking tab clicks
.
Red
Black
DC power cable with fuse holder
Regulated
power supply
Fixed Station Operation
Ext. Power jack
ACC terminal
Cigar-Plug connection
Optional EDC-43 required
REPLACING FUSES
If the fuse blows, determine the cause, then correct the problem.
After the problem is resolved, replace the fuse. If newly installed fuses
continue to blow, disconnect the power cable and contact your dealer
for assistance
.
Only use fuses of the specified type and rating, otherwise the
transceiver could be damaged.
Fuse Location
Fuse Current Rating
Transceiver
15A
Supplied Accessory DC
power cable
20A
If you use the transceiver for a long period when the vehicle battery is
not fully charged, or when the engine is OFF, the battery may become
discharged, and will not have sufficient reserves to start the vehicle. Avoid
using the transceiver in these conditions.
