28
9
TOT (Time-out timer)
The time-out timer limits the amount of transmitting time. When you
reach the time limit which has been programmed by your dealer, your
transmission will be cut off. In order to transmit again, you must release
PTT button to reset the timer.
In standby,press
1.
,then press
“LCD displays "TOT-X".
Press [
2.
/
] to select the desired value.
Press number key to confirm and exit.
3.
CTCSS/DCS Encode and Decode
In standby,press
1.
,then press
to enter into CTCSS/DCS
Encode and Decode.
Repeat above operation to set as below:
2.
LCD displays T icon,it indicates CTCSS encode set in current
channel.
LCD displays T and SQ icon,it indicates CTCSS encode and
decode set in current channel.
LCD displays DCS icon,it indicates DCS encode and decode set
in current channel.
In corresponding icon,press [
3.
/
] to select the desired
CTCSS/DCS encode and decode.
Press
4.
`
,or C/SET to confirm and exit.
Talk Around
This function can be temporarily used in Channel mode. Once the
radio is turned off or switched to another channel, the temporary
setting will be erased and back to initial settings.
By Talk Around function,you can directly communicate with other radios
in your group in case the repeater is not activated or when you are out of
the repeater range. The transceiver will transmit by RX frequency with its
CTCSS/DCS signaling.
In standby,press
1.
,then press
key,LCD displays “TALK--OF”.
Press [
2.
/
] to select the desired setting .
ON:Enable Talk Around
OFF:Disable Talk Around
Press number key to confirm and exit.
3.
This function can be temporarily used in Channel mode . Once the
radio is turned off or switched to another channel, the temporary
setting will be erased and back to initial settings.
Voice Prompt
The prompting tone provides confirmation of entry, error status or
malfunctions of the transceiver. You can enable or disable this function.
In standby,press
1.
,then press
,LCD displays "BEEP--XX”.
Press [
2.
/
] to turn on/off BEEP voice prompt.
BEEP—OF :turn off voice prompt
BEEP—ON :turn on voice prompt
Press number key to exit and store.
3.
HIGH/MID/LOW Power Selection
In standby,press
1.
,then press
,LCD displays"
POW-X
X".
Press [
2.
/
] to select the desired power.
