17
Press
2.
CALL
/
MONI
key to choose No.01 menu, LCD displays ”STP--
125”
Turn selector knob to select the desired frequency channel step.
3.
Channel step: 5K,6.25K,8.33K,10K,12.5K,20K,25K,30K and 50K.
Press
4.
TS/DCS
key to confirm and exit
Press and hold
1.
key for over 2s to
enter setting menu.
Press and hold
1.
key for over 2s to enter the parameter setting
mode.
Press
2.
CALL
or
MONI
to select the desired menu.
Turn selector knob to select the desired parameter.
3.
Press
4.
TS/DCS
to confirm and exit.
Only in VFO mode, this function is valid. Turn selector knob to select
frequency step.
8
PARAMETER SETTING MODE
Frequency Step Setup
This function is not available in memory-mode. (Only available for
pre-programmed units.)
DTMF, DTMF ANI, 2Tone or 5Tone Signaling
DTMF/5Tone/2Tone signalling function as similarily as CTCSS/DCS.
Without receiving correspondent tone signalling, the speaker will remain
mute. DTMF and 5Tone signalling can be applied for other advanced
features such as ANI, PTT ID, group call, remotely stun,remotely kill,
waken,...etc. The signalling edition must be done through programming
software.
Press and hold
1.
key for over 2s to
enter into setting menu.
Press
2.
CALL
/
MONI
to choose No 2 menu,
LCD displays "
T-OFF
" .
Turn selector knob to
3.
select the desired setup.
"DTMF”: the channel will be mute by a DTMF signal. The
speaker won’t be open until receiving a correspondent DTMF
signal. Hold "PTT" then press [UP] or press
CALL
directly to
transmit the pre-stored DTMF signaling.
In DTMF signaling mode, press
CALL
for 2s until LCD displays
"AN---", turn selector knob to select desired digit(
the other party
ID).In this mode, press
TS/DCS
to confirm exist digit and move
cursor to next, press
V/M
to forward cursor.After editing,press
CALL
key to operate ANI call.
"2TONE": the channel will be mute by a
2-Tone signal. The speaker won’t open
until receiving a correspondent 2-Tone
signal.Hold “PTT” then press [UP] or
press
CALL
directly to transmit the pre-
stored 2-Tone signaling.
"5Tone": the channel will be mute
by a 5-Tone signal. The Speaker won’t be open until receiving a
correspondent 5-Tone signal. hold [
PTT
] then press [
UP
] or Press
directly to transmit the pre-stored 5-Tone signaling.
Some menu won't be available depending on the dealer-
programmed setting or operating mode.
The default setting list is availabl on P33
.
