17
Offset Frequency Direction Setup
NOTE: This function is invalid in channel mode.
BASIC OPERATIONS
NOTE: This function is invalid when the main channel is in channel display mode or current mode without
signaling setup. Scan CTCSS when the current channel is set to CTCSS, scan DCS when the channel is set to
DCS.
CTCSS/DCS Scan
While in the CTCSS or DCS mode, Press
A
FUN
key, the top left corner of LCD displays " "
icon, press
3
T.SCA
key to enter into CTCSS/DCS scan. Under this state, press
B
/
C
to
change scan direction. When scan the matching CTCSS/DCS signaling, it will stay 5seconds
and then go on scanning. Press any other keys except
A
FUN
,
M/S
,
#
ENT
/
KL
key to exit.
In VFO mode, Under standby state, press
A
FUN
key, the top left corner of LCD displays " " icon, press
4
key to choose offset frequency direction. There are 3 options, Positive offset,
Minus offset, shut off offset.
1. (+) Positive offset: Indicates TX frequency is higher than RX frequency. When
enable reverse function, the RX frequency is higher than TX frequency.
2. (-) Minus offset: Indicates TX frequency is lower than RX frequency. When enable
reverse function, the RX frequency is lower than TX frequency.
3. None: Indicates that offset is not in use.
