Alimak ALC II, Руководство пользователя

Страница: 40 / 62

Programming of two separate landings at the same
level with a landing push-button each
The lift shall be in normal operation mode.
– Press the Prog. button on the car CPU inside the main panel
until the Prog. LED is illuminated. The lift is now in
programming mode.
The display shows F5 = programming mode (if no landings are
programmed into the system):
– Run the lift with the Up and Down button inside the car
to the bottom landing level. Check that the lift has not
actuated the down limit switch when it is level with the
bottom landing. (The same goes for the top landing).
– Press the Stop Next Landing button.
The system will unlock the doors one by one.
Open suitable door for the landing in question.
(If not, the
landing will be stored as a closed landing).
The Prog. LED goes out.
The first landing level is then programmed into the system
and the system returns to normal operation.
Note: do not operate the lift from this position.
ALIMAK 34837 - 1 /04
A
34
Landing
1
Landing
0
F5 flash on the display for
the single system.
+
+