Align T-REX 450SA ARF, Руководство пользователя

Страница: 53 / 72

53
• Take your time to check the security of all screws on your model. Tighten any screws that may be
loose, and replace any screws or parts that may have been stripped during assembly.
• Check to be sure that all electronic equipment and wire leads are secure and will not come into
contact with any moving parts.
• Check to be sure that the flybar paddles are parallel to the flybar control frame and one another.
• Apply a small amount of lightweight oil (TRI4026) on the main shaft where the swashplate ball and
washout base bushing travel.
• Check to be sure that the bolts for securing the tail rotor blades in the tail rotor blade grips are
tightened so that the blades can pivot in the grips when moderate pressure is applied.
• Apply a small amount of lightweight oil (TRI4026) on the tail rotor shaft where the tail pitch slider
bushing travels.
• Make sure that your ESC is programmed to the correct settings for use in the helicopter with your
chosen motor and battery pack (See the ESC manual for more info).
• Check to be sure that the swashplate, washout, servo arms and all other related parts do not bind
with maximum control inputs. If you experienced any binding, adjust the length of the linkages,
individual servo travel values and/or CCPM travel values to prevent this.
• Take the time to have an experienced helicopter pilot check the assembly and setup of the model.
19.0 Before the First Flight