45
• Network Disconnected:
Disconnected network cable.
• IP Conflicted:
Conflict in IP address setting.
• Illegal Login:
Wrong user ID or password used.
• Video Exception:
Instable video signal detected.
• Mismatched Output Standard Mismatch:
I/O video standards do not match.
To set exceptions:
1.
Enter the Exception menu by clicking Menu > Exception.
2.
Select the exception to configure under
Exception Type
.
3.
Select triggering options, as shown below.
Trigger options are further explained in the next section (See
Understanding Exception
Trigger Options
).
4.
Click OK to save and exit Exception menu.
7.5 Understanding Exception Trigger Options
When setting up exception handlers for such features as motion detection and sensor
alarms, you may select triggering options to alert you of these exceptions.
The triggering options that you may select include:
Pop-up Image on Monitor:
When an alarm is triggered, the local monitor (VGA or
BNC monitor) will display an image under Live Preview mode. This alarm can be
configured under the Popup Alarm Image handle method. For alarms that are triggered
simultaneously, images will be displayed one at a time every 10 seconds (default dwell
time). A different dwell time can be set by going to Menu > Setting > Display > Dwell
Time. Once the alarm stops, cycling of the images will also stop and you will be returned
to the Live Preview screen.
• Audio Warning:
Trigger an audible
beep
when exception is detected.
• Notify Surveillance Center:
Sends a signal to remote alarm host when exception is
detected (See
Configuring a Remote Alarm Host
).
• Trigger Alarm Output:
Trigger an alarm output when exception is detected. Alarm
output can be configured by following the steps listed in
Setting Up Sensor Alarms.
Intelligent Security and Fire Ltd
