1
www.observint.com
ALI-TS2018VR_CQ
190708
Switch*
button
Cap for
switch
button
12 Vdc power in
HD video BNC connector
* Press and hold switch button for 5 seconds to change the video format. See cable tag.
Camera drop cable connectors
What’s in the box
•
Camera assembly
•
Mounting hardware
•
Security L-wrench
•
This instruction guide
•
Drill template
Tools you need
To install the camera, you will need:
•
12 Vdc power source. See
Specifications
for requirements.
•
Tools and additional fasteners (may be required) for mounting the camera
•
Video and power extension cable
Installation
Before installation:
•
Make sure that the device is in good condition and all the assembly parts are included.
•
IR Reflection Prevention
: Avoid mounting the camera near reflective surfaces. The IR light from
the camera can reflect back into the lens. Do not remove the plastic cover until the cover is installation
is complete.
•
Check the specification of the products for the installation environment.
•
Make sure that the wall or the ceiling is strong enough to withstand 3 times the weight of the camera.
•
To avoid fire or shock hazard, use only UL listed power supplies. Verify that the power supply will
provide the rated voltage and wattage for the camera. See the
Specifications
section.
During installation:
•
Camera Lens
: Handle the camera carefully to prevent scratching or soiling the lens. If the lens or IR
array shield becomes soiled, clean it only with approved products. See the
Cleaning
section.
•
Power supply
:
Camera drop cable
: The camera drop cable includes two connectors:
—
Video BNC connector
: For transmission of the video signal across a coax (75 Ω) extension
cable.
—
Power connector:
When applying Vdc power, observe the power polarity. See the drop cable
photo above for the connector polarity configuration.
Step 1. Mounting the camera
These cameras can be mounted on a wall or ceiling that has sufficient strength to support it. The video/
power drop cable from the camera can be routed either through mounting surface or through a cable guide
on the edge of the mounting base.
NOTE
This camera can be installed using a pendant mounting bracket with flange adapter or junction
box. Please refer to the instructions provided with those accessories for special considerations when
installing the camera with them.
1.
Unscrew the three (3) dome assembly screws, and then separate the dome assembly from the
mounting base. The dome is tethered to the base with a strap.
NOTE
: To keep the lens assembly
clean, do not remove the plastic protective packaging applied to the lens at this time.
ALI-TS2018VR 8MP TVI/AHD/CVI/CVBS
120 ft IR Vandalproof Outdoor Dome
Camera Quick Installation Guide
The ALIBI ALI-TS2018VR dome camera include a 4 -in-1 switchable video output with an 8.29 MP sensor.
Features include:
•
8.29 Megapixel (3840 x 2160 pixels) high-performance CMOS sensor
•
Switchable video output for TVI, AHD, CVI, or CVBS
•
2.8 mm lens, 102.2
˚
horizontal field of view
•
Low light 0.01 lux color illumination
•
Up-the-coax OSD menu,105 dB DWDR
•
EXIR 2.0 technology, smart IR, up to 120 ft IR distance
•
IP67 weatherproof, IK10 vandalproof
•
Flange adaptor for pendant mounting (ALI-AF4) and junction box mounting (ALI-AJ4) are available
Mounting
base
Cable
guide
Dome
assembly
Dome
assembly
screw (3)
Lens
IR LED
Hole for
mounting
screw (3)
Product
label
Drop cable
Cable
guide
Camera mounting surface
