Installation instructions
Installation instructions
Suggested tools
1. Screw driver (medium size Phillips)
2. Tape measure or ruler
3. Knife or scissors
4. Level gauge
7
5
~
1
5
0
c
m
Over 50cm
About 10mm
AWNING
FENCE
7
5
~
1
5
0
c
m
Over 50cm
About 10mm
AWNING
FENCE
Note: Unit may be supported by a solid frame
from below or by a hanger from a solid
overhead support.
Preferred method of installation into a timber
framed wall, partition or window.
Flash or seal around external
wall frame or architrave
Sturdy timber frame
all round unit
Timber framed
wall or partition
External support frame
at balance point of a/c
Alternatively, brackets
as illustrated below
may be used.
Drain pan
Select the best location
1. To avoid vibration and noise, make sure the unit is installed
securely and firmly.
2. Install the unit where the sunlight does not shine directly on
the unit. If the unit receives direct sunlight, build an awning
to shade the cabinet.
3. There should be no obstacle, such as a fence or wall, within
50cm from the back of the cabinet because it will prevent
heat radiation of the condenser.
Restriction of outside air will greatly reduce the cooling
and heating efficiency of the air conditioner.
4. Install the unit a little obliquely outward not to leak the
condensed water into the room (about 10mm or 1/4 bubble
with level).
5. Install the unit with its bottom portion 75~150cm above the
floor level.
6. The power cord must be connected to an independent cir-
cuit. The yellow/green wire must be grounded.
All side louvers of the cabinet must remain exposed to
the outside of the structure.
CAUTION
Step 1
Remove the air conditioner from its packaging, remove fixing screws,
front panels ( for some models) and slide the air conditioner out of
its housing (Refer to Installation Steps).
Step 2
Prepare the hole in the wall so that the bottom of the housing is well
supported, the top has minimum clearance and the air inlet louvers
have clearance as shown below in options A and B (see next page).
Holes from the outside through to the cavity should be sealed. The
housing should slope down towards the rear by about 10mm to allow
water formed during operation to drain.
Step 3
Install the housing into the wall and secure. Ensure the foam seals
are not damaged. Flash, seal or fill gaps around the inside and out-
side to provide satisfactory appearance and protection against the
weather, insects and rodents.
Installation of the Housing
