Algas SDI VAPORAIRE M-Series, Руководство по эксплуатации и техническому обслуживанию

Страница: 21 / 72

Algas-SDI Operations & Maintenance Manual – P/N - 54264
2-13
2. Installation
WARNING
The equipment described in this manual is designed to operate with
LP-gas, a flammable fuel under pressure. The nature of the
application involves inherent hazards that could result in injury.
ONLY a trained and fully qualified person should service this
equipment.
CAUTION
Make sure that the mixer system is properly installed, that all
connections and pressure connections are complete and tight, and
that all system electrical safeties are operating and adjusted
properly.
NOTE
This product has been pressure tested at 200 PSI as part of ASDI’s
quality assurance procedures. Prudent installation practices
include pressure testing of all piping systems. Be sure to address
personnel safety issues and component design parameters when
testing for leaks.
NOTE
In mixers using the SEQUENCER, the software program for
controlling the blending operation is set at the factory. Any attempt
to change the software voids the operating warranty.
Installation requirements vary according to local, provincial and state
requirements. Consult state, provincial and local authorities as well as insurance
carriers for installation requirements.
All components must be installed in accordance with applicable codes and local
regulations as required.
Mixer controls are set at the factory. However, vibration in transportation may
alter the settings or it may be desired to change the system delivery pressure
(within the range of the installed venturis). Thus, the control settings will need to
be checked and may need to be re-adjusted. Any replacement controls will also
require adjustment.
Mixing systems with voltages other than 120 VAC will have an external mount
transformer that is shipped loose. The transformer is in a general-purpose
enclosure and needs to be wired according to applicable electrical codes.