Algas SDI Second Sun, Инструкция по установке, эксплуатации и обслуживанию

Страница: 13 / 33

ASDI Installation, Operation and Maintenance Manual
– SECOND SUN – P/N 51856
5
INSTALLATION
2
GENERAL REQUIREMENTS
Install the Second Sun
™ on a “raised” tank to allow space for the heater to be
rotated under the tank. Inspect the heater face visually for any damage to the
catalyst material. At the same time, the tank surface, covered by the heater,
should be inspected for corrosion, using the same method for inspecting all other
exposed surfaces. Clean all foreign materials from all pipelines prior to making
any connections to Second Sun
™. Use pipe sealant approved for LPG use
where required. Check all connections for leaks using leak detection solution or
device. Eliminate all leaks prior to operation.
Install in accordance with NFPA 58 and local applicable codes and regulations as
required.
Figure 2
– Typical Second Sun ™
Installation
NOTES
1. INSTALL THE TANK STRAPS WITH DIRECTIONS GIVEN
BELOW BEFORE ATTEMPTING TO MOUNT THE HEATER.
2. INSTALL THE PROVIDED GAS REGULATOR ASSEMBLY TO
YOUR TANKS MULTI-VALVE WITH NECESSARY FITTINGS.
3. DO NOT PLACE HEATER ON ITS BACK AT ANY TIME TO
AVOID DAMAGE TO CRITICAL COMPONENTS OF SECOND
SUN
™
.
4. DEPENDING ON SIZE OF THE TANK BEING PRESSURIZED,
ADJUST HEATER FACE INSIDE ITS COVER TO KEEP IT
1INCH AWY FROM THE TANK WALL.
Raise tank to
allow space for
heater to be
rotated under
the tank.
Rotate heater
bottom edge
under tank to
lowest point.
Mounting bands
should be
moun
ted 63.5”
spacing