SPECIFICATIONS
MENU OPERATING INSTRUCTION
- Lighting sources:
LASER Red 638nm/ 120mW
LASER Green 520nm/ 80mW
LASER Blue 450nm/ 290mW
- 2000 built-in programs: Tunnel effect, wave, ceiling effect, paterns...
- Mode Music, Auto and DMX
- 6 or 34 DMX channels
- DMX connectors : XLR 3 pins
- ILDA interface IN &OUT
- Security KEY and INTERLOCK connector conformed to EN 60825-1:2014
- Mirror motors : Scanners 20Kpps
- Cooling system : fan
- Electric consumption : 50W max.
- Power supply : 110-230V AC -50/60Hz
- Net weight :2,25kg
- Dimensions : 26x26x15cm ( with bracket)
IMPORTANT !
An «Interlock» connector cap is included in the box with this device. If you are not using system such as
an Emergency RED Button ( optional ... not included in this package) to shut down the LASER beam in
case of danger, you MUST connect this CAP to the INTERLOCK connector ( see (10) in previous page).
Without this CAP connector, the LASER beam will be turned off.
Emergency Red Button
( Optional, Not included with the product)
Interlock connector CAP
INTR
DMX
SND
A 1-512
with «
DMX
» = DMX mode 34 channels
-Select DMX address with then press
ENTER
A 1-512
with
DMX + INTR
= DMX mode 6 channels
-Select DMX address with then press
ENTER
AL
= Auto mode , play all SELECTED programs
SE
= Internal program SELECTION
SND
= Mode «SOUND» / music. Select this mode with ENTER button.
&
&
Advanced menu.
In AUTO mode ( AL) and also in music mode (SND) ,the device plays all programs ( SE1 to S15).
It is possible to select the internal program which will be played into AUTO program.
- Press and hold MODE button for 3 seconds
- With buttons ,select the internal program you want to valid or not into the AUTO program, then press ENTER
to confirm selection. ( symbol«
SEL
» will be displayed once the program is selected)
DR- II :
Reverse pattern horizontal , press
ENTER
DR- :
Reverse pattern vertical, press
ENTER
DR- II :
Reverse horizontal and vertical patten., press
ENTER
II 10-100
: Pattern horizontal size, press
ENTER , then
10-100
: Pattern vertical size , press
ENTER then
fOFF
: no function
OADJ
: pattern testing
-Press again 3 seconds the MODE button to exit this menu.
&
SEL
&
&
