english
7.
Attach the battery compartment (10). Insert the
switch (12) and the three spring connectors (11) in
the right position, as shown (Fig. 8.). Careful! The
pin on the switch that does not have a wire must
be in front. Set the switch in the forward position,
which is “Off”.
Fig. 8
Fig. 9
Fig. 10
Fig. 11
8.
Attach the three spring connectors (11) and
connect the wires to the spring connectors as shown
in Fig. 9:
Red motor wire – 1
Black motor wire – 3
Red switch wires – 1, 2
Red battery compartment wire – 2
Black battery compartment wire – 3
Bend the spring to create an opening where you can
insert the metal end of the wire.
9.
Attach the plastic rings (5) over the rear wheels
as shown in Fig. 10.
10.
Insert the batteries (see “Inserting the batteries”
below) and push the switch to the back position to
start your Robotic Ball Collector. Lay out the balls
included in front of the robot and watch how they are
collected by the arms!
