Alfresco G4ALF2BI, Инструкция по сборке и эксплуатации

Страница: 13 / 27

Page 13
LIGHTING INSTRUCTIONS
After confirming there are no leaks:
1. Open the hood of the barbeque while lighting the main burners.
2. Turn all the control knobs clockwise to “OFF” position.
3. Connect the regulator to the gas bottle. Turn the gas supply “ON” at the gas cylinder.
4. Push IN selected burner control knob and keep pressing IN whilst turning anti-clockwise to the
“HIGH” position (a clicking sound is heard). This should light that burner. Observe if the burner is lit,
if the burner is not lit, turn the knob clockwise to “OFF” and repeat this step once.
5. If the burner has not lit after retrying once, turn the control knob “OFF” (clockwise) wait five
minutes and repeat step 4.
6. If the burner still does not light, light the appliance with a lit match held next to the burner, consult
your store of purchase if necessary to service the ignition.
Warning: If the burner completely fails to ignite, turn the control knob clockwise to “OFF” and also
turn the cylinder valve “OFF”. Wait five minutes before attempting to relight with ignition sequence
from STEP 1.
CONTROLLING THE MAIN BURNER FLAMES
Adjust the heat by turning the knob between the “HIGH” and “LOW” positions.
Light individual main burners in the same way as above.
To turn the complete barbeque “OFF”, turn the cylinder valve or regulator switch to the “OFF”
position and then turn all the control knobs on the appliance clockwise to the “OFF” position.
Before cooking for the first time, operate the barbeque for about 15 minutes with the hood closed
and the gas turned on “LOW”. This will “heat clean” the internal parts and dissipate odour from the
initial “burn in”.
Lighting the bbq