ALFRA SKF 63-15, Руководство по эксплуатации

Страница: 21 / 69

21

The ALFRA bevel milling machine SKF 63-15 is a unit for the preparation of welds, bevelling of
metallic materials resp.

The low weight (please compare with our competition) enables the use on almost every work
place and a rattling-free, steady milling operation.

The machine is suitable for milling steel, VA, cast iron and nonferrous heavy metal by one-hand
operation.

To make operation easier the SKF 63-15 is equipped with a wheel-table plate.
4.1 Technical Data
Motor/Voltage:
230 V AC, 50 Hz
– other voltages / frequencies on request
with overload protection and restart barricade.
Capacity:
1100 W Rotation Speed: 2870 min
-1
Land Width: 15 mm max., progressively adjustable
Weight: 21 kg
Bevel Angle: 15-20-30-45-60° progressively adjustable
Dimension (L x W x H): 440x200x280 mm
Tools:
2 units off disk milling cutters

63 mm, each with 6 pieces indexable inserts.
5. Adjustment of Land Width
The bevel milling machine is factory adjusted to a land width of 2 mm.
In order to adjust your required land with, detach both fastening screws (13) underneath the star
handle.
By turning the star handle (12) you can now shift the housing within a range of 0 - 15 mm.
Land widths exceeding 15 mm are not recommended. In order to protect machine and tools you
should generally advance land widths of more than 5 mm in multiple steps.
Marks on the scale sheet
I I I I enable the reading of the land width.
(corresponds to 0 7 14 22 mm appr. with a 45° bevel angle)
After adjustment it is imperative to tighten the fastening screws again.
Star handle
screw (12)
Adjustment of
Land Width (13)
Scale right
(20B)
Adjustment of
Bezel Angle (30)