6/32
ALFA IN a.s ©
www.alfain.eu
extraction system.
18.
In addition, a respiratory mask is required when cutting material that
produces particularly dangerous fumes.
19.
The machine produces a noise level of 80-85 dB.
20.
For prolonged work, we recommend the use of hearing protectors.
Prohibited activities
1. It is forbidden to use the machine in explosive areas and areas where
flammable and combustible substances may be present.
2. It is forbidden to carry out cutting of containers with residues of any
flammable or unknown substances.
3. It is not permissible to carry out cutting on closed pressure vessels without
first releasing the pressure and leaving them open.
3. OPERATING CONDITIONS
1. The commissioning of the instrument may only be carried out by trained
personnel and only within the technical provisions. The manufacturer is not
liable for damage caused by improper use and operation. Only use original
ALFA IN spare parts for maintenance and repair.
2. The device complies with IEC 61000-3-12.
3. The cutting machine is tested according to the standard for protection class
IP 23 S, which provides protection against the ingress of solid bodies with
a diameter greater than 12 mm and against the ingress of water falling in
a vertical to oblique direction up to an inclination of 60°.
4. Operating ambient temperature between -10 and +40 °C.
5. Relative humidity below 90% at +20 °C.
6. Up to 3000 m altitude.
7. The machine must be positioned in such a way that cooling air can enter
and exit through the cooling vents without restriction. Care must be taken
to ensure that no mechanical particles, especially metal particles (e.g.
during grinding), are drawn into the machine.
8. If the machine overheats, cutting is automatically interrupted.
9. All interventions in the el. equipment, as well as repairs (removal of the
mains plug), may only be carried out by an authorised person.
10.
SVAROG 125 PLASMA is designed for a mains voltage of 3x400 V.
11.
The relevant mains voltage and input power must be matched to the
mains plug.
12.
The cutting machine must be subjected to a periodic inspection once
every 6 months by an authorised person in accordance with ČSN
331500,1990 and ČSN 050630,1993.
13.
The cutting machine is primarily designed for industrial environments
in terms of interference. Special precautions may be necessary for use in
other areas (see EN 60974-10).
14.
Above all, the machine must be protected from: