27/32
ALFA IN a.s ©
www.alfain.eu
3. Unplug the machine from the mains before replacing torch parts.
4. Disconnect the machine from the mains before any intervention inside the
machine.
5. The machine is adapted for the use of the Plasma SVH-105 torch. In this
combination, it forms a safe system in accordance with ČSN EN 60974-7
Article 10.1.4.
6. The SVAROG 125 PLASMA must not be directly connected to a pressure
source of more than 8.5 bar or to cylinders! Connection to such sources is
only possible via a suitable pressure reducing valve that is tested for the
appropriate inlet pressure and flow.
7. Imperfect trapping of the condensate will cause it to discharge in the torch
cutting tip area and prevent the pilot arc from igniting.
Causes of poor quality cuts
Insufficient cut penetration
1. High cutting speed (make sure that the inclination of the penetrating cutting
arc does not exceed approx. 15° (see Fig. 13).
2. High cutting tip or electrode wear (see Fig. 14).
3. Large material thickness and improperly selected cutting current and
cutting tip diameter.
4. Poor electrical contact between the grounding clamp and the material.
Notice
If the cutting arc does not penetrate the material perfectly, the splashing material
clogs the torch cutting tip and reduces its service life.
The cutting arc is unstable, goes out and "shoots"
1. Worn cutting tip or electrode
2. High air pressure
3. Polluted air
4. Uncaptured water condensate
Notice
An unstable arc causes very intense interference that can cause the machine
control system to collapse or endanger surrounding equipment!
Conical cut
1. If a crooked incision occurs (see Fig. 15), switch off the machine, release
the shield cup and rotate the cutting tip by about 1/4 and try cutting again.
2. Damaged cutting tip and electrode.
3. The position of the torch is not perpendicular to the material
4. Large distance of the torch from the material
5. Worn electrode or cutting tip