- 19 -
ALFA IN a.s. ©
www.alfain.eu
feeder with the generator by means of cable bundle A21.
•
Plug the mains plug to 3x400 V mains.
•
Switch the machine on by the ON/OFF switch A1
•
There will appear type of the machine and software version on the
displays for ca 3 s time – not on BASIC.
•
Then the machine will enter the manual program (P0) and on the left
display will be the wire speed in m/min (or the last parameters of previous
settings). On the right display will appear symbol --- (in manual P0
program) or the recommended settings (in programs P1 – P9) - not on
BASIC
7.1 INSERTING THE WIRE
Fig. 10 – Spool holder
•
Open the side cover of the wire feeder space
•
Put the wire spool on the wire spool holder D1 using the adapter D3 and
fix it with the fixing nut D2
•
Cut off the curved or damaged end of welding wire and lead it through the
inlet liner E3, and the roll into the liner inside the EURO torch connector
(about 5 cm). Make sure, that you use the suitable groove.
•
Put the pressure arm E2 down in that way, that the teeth or the gear fit
and fix it by setting the lever E1 into vertical position.
•
Adjust the pressure nut that way that it provides constant movement of
wire but it does not deform wire.
7.2 INSERTING THE WELDING WIRE INTO THE WELDING TORCH
D1
Spool Holder
D2
Nut Spool Holder
D3
Adapter
