Alecto WS-5500, Руководство пользователя

Страница: 50 / 60

50
7. OPERATION
7.1 First time use:
General:
Attention: after installation, it can take several hours up to a day before
the display of the indoor unit starts showing the correct values.
Indoor unit/outdoor unit connection:
Indoor unit:
As soon as the power adaptor is connected to the indoor unit and to a
230V wall socket or as soon as the batteries are inserted, the indoor
unit starts searching for the outdoor unit.
Outdoor unit:
Insert the 2 batteries into the battery
compartment as described in the previ-
ous chapter and use a bend paperclip
to press and hold the reset button at
the bottom of the outdoor unit for at
least 3 seconds. The red LED will now
illuminate for 4 seconds and then start
flashing briefly every 16 seconds.
Check whether the indoor unit starts showing values at ‘OUTDOOR’,
blow against the wind catchers of the outdoor unit, pour some water into
the rain gauge and check whether the values indicated by the indoor
unit change.
Standard display:
From this moment on, the indoor unit shows the standard display; see
paragraph 5.1 for an overview of all displays.
Paragraph 7.2 describes how the various settings and options of this
weather station operate and must be set. Paragraph 7.3 describes how
you may personalise the display according to your preferences.
7.2 Basis setup:
Press and hold the SET button for 2 seconds to activate the setup
menu:
BEEP Each time you press one of the touch control but-
tons, you can have the unit emit a beep tone. Use
the + and - buttons to enable (BEEP ON) or disable
(BEEP OFF) this key tone.
Press 1x the SET button:
HI:LO RST Each day at midnight all measured maximum and
minimum values may be reset, with the exception of
the rainfall data. Use the + and - buttons to enable
the reset of these values (RST ON) or to disable the
reset (RST OFF).
The rainfall values must be reset separately, for this
please see chapter 7.3.
Press 1x the SET button: (*)
DST DST = Daylight Saving Time.
Use the + and - buttons to have the switch-over to
daylight saving time and vice-versa occur automati-
cally (DST ON) or not (DST OFF).
Press 1x the SET button:
ZON This option allows you to adjust the time zone. For
use in the Benelux, set the time zone to 1H.
Press 1x the SET button:
12H / 24H Use the + and - buttons to choose the 12 hours or
24 hours time format.
Press 1x the SET button:
HOURS FLASHING
Use the + and - buttons to set the hours.
Press 1x the SET button:
MINUTES FLASHING
Use the + and - buttons to set the minutes.
LED
reset
button