-35-
Indoor unit:
Insert 2 Alkaline batteries type AA 1.5 Volt into the battery compartment
of the indoor unit according to the correct polarity. After the batteries
are installed, the indoor unit will emit a short beep tone and start the
synchronization with the outdoor unit. During this period, please don’t press
any buttons, but wait until the first data from the outdoor unit is shown.
Following the synchronization period, the indoor unit will start searching for
the DCF time signal from Frankfurt for the current time.
The indoor unit is provided with a built-in DCF receiver for receiving the DCF
time signal sent from Frankfurt. This signal ensures that the clock will display
the precise current time, provided the signal is being received properly. Each
day, the DCF time is synchronized with the signal from Frankfurt at 2am,
8am, 2pm and 8pm. After installing the batteries, the indoor unit will also
start searching for the DCF signal. When the reception succeeds, the
icon will appear.
It can take up to several hours before the time signal is received. When the
reception fails, you can try rotating the indoor unit until it does receive the
DCF signal.
After installing the batteries, the indoor unit will try to make contact with
the outdoor unit for the synchronization. After the synchronization has
succeeded, the outdoor temperature and humidity will be displayed. During
the reception the “
” icon will appear.
During the first 10 minutes, please don’t press any buttons otherwise the
synchronization might fail.
If the outdoor temperature doesn’t appear after 10 minutes, please repeat
the registration procedure.
If the DCF time doesn’t appear quick enough, you can set the time manually
(see “setup”).
ATTENTION:
during the registration process, please don’t press any
buttons.
Registering additional outdoor units:
The WS-1100 indoor unit can receive data from 3 outdoor units
simultaneously.
• Press and hold the “CHANNEL” button for 3 seconds until you hear a beep
tone.
• Now insert the batteries into the outdoor unit you like to register.
•
Don’t press any buttons until the data appears on the display.
Registering multiple outdoor units simultaneously:
• Press and hold the “CHANNEL” button for 5 seconds until you hear a
second beep tone.
• Now insert the batteries into the outdoor units you like to register.
•
Don’t press any buttons until the data from all outdoor units is being
received.
