13W Engraver
AFTER SALES SUPPORT
(toll free)
MODEL No.: DC-11-1 • 07/2019 10283
e-mail: [email protected]
AUS
11
1300 889 028
AUS
Operation
WARNING!
• Always wear safety glasses when using this tool.
• After 30 minutes continuous working, the tool needs to be stopped
to cool down to room temperature before use again.
Using the engraver (see fig. B)
1) Before using the engraver you must ensure there is an engraving tip
(1) installed.
2) Connect the engraver power cord (4) to the power supply and hold
the engraver firmly.
3) To turn the engraver on, press the on/off switch (3) to the “I”
position. To turn the engraver off, push the on/off switch (3) to the
“O” position.
4) Hold the machine in a vertical position (almost 90°to the workpiece).
Try to execute individual lines in one uniform movement without
stopping if possible as later on it will be possible to make out paused
and uneven movements on the engraved workpiece. Sketch out the
outlines on the workpiece prior to engraving if necessary (e.g. with
the aid of the stencils provided. It may also assist to clamp down the
stencil onto the work piece to sketch the outlines) in order to make
it possible to engrave more even lines.
NOTE:
Do not press down hard while engraving, use light pressure
while guiding the point over the work to be completed.
