13W Engraver
AFTER SALES SUPPORT
(toll free)
MODEL No.: DC-11-1 • 07/2019 10283
e-mail: [email protected]
AUS
10
1300 889 028
AUS
Assembly
Installing an engraver tip (see fig. A1, A2)
WARNING!
Disconnect the engraver from the power supply,
turn the on/off switch (3) to the OFF position, before making any
adjustments or undertaking maintenance procedures.
1) Loosen the tip release screw (7) by turning it anti-clockwise with the
hex key (6) supplied.
2) To fit the new engraving tip (1), insert the tip through the centre
of the hole of the engraver, ensuring the tip fully enters the
housing. A new tip should protrude from the end of the housing by
approximately 8.5mm.
3) Tighten the tip release screw (7) fully by rotating in a clockwise
direction.
A2
A1
