ALDI WB 12-2, Руководство пользователя, Страница: 22 / 35

Operation
22
Cordless drill
meister-service@meister-werkzeuge.de
AFTER SALES SUPPORT
GB IRE
GB IRE
00800 34 99 67 53
8. Observe the following notes on screwing and drilling:
Screwing • You can drive screws into soft wood without drilling a
hole in advance.
• Pre-drill when screwing into hard wood and driving in
large screws.
• Countersink the drill hole for countersunk screws.
• In case of wood screws without continuous threading,
pre-drill half a screw length.
• If the set torque is exceeded, the slip clutch will block
the rotation of the quick-action drill chuck.
Drilling (in general) • Pull the drill bit out of the drill hole regularly so that it
can cool off.
Drilling (wood) • Centre punch the marking for the drill hole with a centre
punch.
• Place a wood block under it or drill from both sides to
prevent the wood from breaking off when breaking
through.
• Use an HSS wood drill bit (not included in the pack
contents).
Drilling (metal) • Centre punch the marking for the drill hole with a centre
punch.
• Clamp in the metal sheet and place a wooden block
under it to prevent deformation.
• Use an HSS spiral drill bit.
• Use a smaller drill bit to pre-drill the hole for a large bore
diameter.
• Use a lubricant for steel and aluminium
Steel: oil
Aluminium: turpentine, paraffin
Brass, copper, cast iron: do not use a lubricant
9. First gently push the On/Off switch to start the cordless drill.
If you push the On/Off switch, the LED work light 9 will turn on to illuminate
poorly lit work areas.
10. Afterwards, push the On/Off switch while applying more pressure.
The rechargeable battery may heat up depending on the load. Let the
rechargeable battery cool off.
11. Hold the On/Off switch down until you have finished your work.