First use
19
7. Let go of the On/Off switch to switch the product off.
8.
If you stop working or put the product down:
Make sure that the product has stopped moving, and lock the On/Off switch by
pushing the switch (right-hand/left-hand rotation)
5
to the middle position in
order to prevent it from accidentally switching on.
9. An operating temperature between 4 °C and 40 °C is recommended.
Setting the mode and direction of rotation
− Use the changeover switch
9
to select the desired mode (see
Fig. 4
).
4
9
•
Drilling/Screwing
: Press the button on the side of the changeover switch and
turn the ‘drill’ symbol
to the marker.
•
Hammer drilling
: Press the button on the side of the changeover switch and
turn the ‘ Drill’ symbol
to the marker.
Please note that only a little pressure needs to be applied when hammer drilling.
Applying too much pressure stresses the motor and could damage it.
− Use the switch (right-hand/left-hand rotation)
5
to select the desired direction
of rotation (see
Fig. 1
).
•
Right-hand rotation:
Push the switch on the right side as far as it goes into
the product housing.
Use right-hand rotation (product rotates clockwise) for drilling, hammer drilling
and tightening screws.
•
Left-hand rotation:
Push the switch on the left side as far as it goes into the
product housing.
Use left-hand rotation (product rotates clockwise) to loosen screws or remove
jammed drill bits out of the hole.