Alcorn Mcbride Digital Binloop HD, Руководство пользователя

Страница: 29 / 137

Alcorn McBride Binloop User’s Manual Page 19
Parallel Control
The Binloop’s Parallel Control interface is designed to provide a very
basic control from simple voltage and contact closure inputs. This
interface also has 3 dry-contact relay outputs and 2 TTL level outputs
that indicate the status of the Binloop. All of these signals are available
on the DB-37
Parallel Control connector located on the back of the
Binloop.
Parallel Inputs
The following table lists the available inputs of the Binloop’s Parallel
control interface, as well as description of their functions:
Function Contact
Closure
Pins
Voltage
Pins
Description
*Start
7(+),8(-) Start SMPTE
*Pause
9(+),10(-) Pause SMPTE at next SMPTE loop
point
*Stop 11(+),12(-) Stop SMPTE, Stop all reproducers.
*Mute Audio 13(+),14(-) Mute Audio on all reproducers
Play Group #1 20, GND** Play and Loop clip #1 on Group #1
Play Group #2 21, GND** Play and Loop clip #2 on Group #2
Play Group #3 22, GND** Play and Loop clip #3 on Group #3
Play Group #4 23, GND** Play and Loop clip #4 on Group #4
Play Group #5 24, GND** Play and Loop clip #5 on Group #5
Play Group #6 25, GND** Play and Loop clip #6 on Group #6
Play Group #7 26, GND** Play and Loop clip #7 on Group #7
Play Group #8 27, GND** Play and Loop clip #8 on Group #8
Reset SMPTE 28, GND** Stop SMPTE
Idle SMPTE 29, GND** Pause SMPTE immediately
Stop Group 31, GND** Changes the behavior of pins 20-27
to Stop the group (instead of play
and loop)
Loop Inhibit 32, GND** Changes the behavior of pins 20-27
to Play the group (instead of play
and loop)
*These functions are identical to the front-panel control buttons of the
Binloop.
**GND can be any one of the ground pins on the Binloop’s Parallel
Control Connector. This includes pins 16, 17, 18, and 19.