alchemy Alchemy RB1000, Инструкция по установке и эксплуатации

Страница: 12 / 40

12
LEVELLING OF BURNER
When installing the Bioethanol fire, level the complete firebox by using the fitted legs. If the flame
does not cover all the burner, side to side while the setting on high flame, then, it will be necessary
to level the burner by using the screws, See Figure 2.
• If no flame or weaker flames on the left side: Turn the screws of the legs on the right-hand side
anticlockwise for 2 turns (to raise the right-hand side). Wait for 3 minutes and check again.
• If no flame or weaker flames on the right side: Turn the screw on the left-hand side anticlockwise
for 2 turns (to raise the left-hand side). Wait for 3 minutes and check again.
• Repeat the procedure described above until the flames are reasonably level.
Alternatively, the burner can sit into a recess and be sited on the burner enclosure frame. The
opening size for the recess must be:
Recess sizes:
RB700 RB1000 RB1500
Min-Max Width 705mm - 710mm 1030mm - 1035mm 1530mm - 1535mm
Min-Max Depth 245mm - 250mm 245mm - 250mm 245mm - 250mm
The rear of the burner needs an additional 40mm clearance for the plug under the rear lip of the
surface base.
Import Note – the dimensions above are base on a base opening made from 1mm steel, if you
are using a thicker material you will need to increase the depth to allow the Burner insert to be
tipped in to place with the plug in position.
The burner must be within 1mm+/- of levelness to ensure even flame spread across the burner.
Fig.2
50cm
2
free flowing air min. under and
around the base of the burner