Alcatel SpeedTouch 610, Руководство по эксплуатации

Страница: 20 / 56

3EC 37770 AAAA TCZZA Ed. 02
1 SpeedTouch™610 Installation
16
1.3.2. Configuration Setup for other OSs
Supported OSs
As the SpeedTouch

610 is OS independent, this configuration setup can be used by any
computer system
Note: In fact the following procedure may equally be used on MS Windows OSs for
configuring the SpeedTouch™610.
TCP/IP
Make sure that TCP/IP is installed on your computer(s).
Configure every PC with a static Net10 private IP address, e.g. 10.0.0.1, 10.0.0.2, etc.
Make sure though NOT to use the 10.0.0.138 IP address as this is the default IP address
of the SpeedTouch™610.
To test IP connectivity, ping the SpeedTouch

610.
Procedure
Step Action
1
To make sure that the SpeedTouch

610 is in its factory default state, perform
a reset to defaults. For more information, see the application note “Speed-
Touch™ Operation and Maintenance”.
2
Open a web browser and browse to the SpeedTouch

610's default IP address
10.0.0.138. See chapter “2 The SpeedTouch™610 Web Interface” on page 19
for more information.
3
Click Upgrade in the System Config Menu to open the Upgrade web page.
4
In the Configuration window, click Browse next to the Configuration file path
input field to locate the configuration file on the CD-rom or disk.
Note: If the path is known you can immediately enter it in the Configuration
file path input field.
5
Click Upload to start the upload.
6
Click Restart to restart the SpeedTouch

610 and activate the uploaded
configuration.
7
After restarting the SpeedTouch

610 some additional configuration of your
computer system might be needed.
Note: The required settings for your computer should be provided by your
Service Provider, if applicable.
8
To check whether the activation of the uploaded configuration was successful,
you can browse to the SpeedTouch

610 and overview the current configura-
tion.